No strengths.

First one burnt out. No IPR was offered when second one was purchased. Eventually one fan power output died, then another and another and now I have removed the fans completely and just hope the RGB control holds up. I have a corsair 1000D case and do not have many options for RGB control as I've replaced my AX-E5 sound card.

Only buy with 4 years IPR and hope it doesn't catch fire within your case.

Has a lot of fan headers

Fan headers have burnt out on two units now

I created a build that contains 9 LL120 fans, and 3 Kraken fans The 9LL120Fans were plugged into the Corsair Commander directly + some splitters and initially this lasted from August to March with no problems. However, in March, most of the fan headers started failing, and I thought it was because I had setup at one point 3 fans to 1 port. Thinking this was overdrawing current, I decided to bite the bullet and buy another unit, but this time I'd split at most 2 fans to 1 port. This new unit lasted a month b4 one of the headers failed, and today, two months later, another header has failed. I'm now considering using a few of the NZXT fan controller instead since that one hasn't failed my 3 kraken fans yet.

Love the icue software to control all my fans, i have 3 of these controllers, becuase i got 13 QL fans in my computer and never had a problem since i booted my computer up the first 3 months ago. I dont use any fan curves as i got 3 rads and just have all fans at 800rpm unless i am gaing were i set to 1400rpm.

It gets messy with how many wires corsair icue system has, and with my build i spent 2 days cleaning up wires cause i got an open case build. HOWEVER, my hydro x pump would not run when pluged into the commander, i lucky had a water pump port on my motherboard i had to use.

Overall except fromvthe pump, one of the best systems. Easiest and best software compared to other brands.

Great for controlling fan speed and be8ng able to set custom fan speeds.

2 days after installing it my fans quit running glad i went down in my basement when I did. Tried everything to get it back up and running Without having to open up my pc case. However in the end I ended up opening the back panel disconnecting the power and plugging it back in and it worked. Did some research afterwards found out it ended up going into some kind of boot loader mode. I hope it doesn’t happen again.

Watch what you buy from Corsair. Not everything of theirs works the greatest

Works with 3 or 4 pin fans. Options to control fans based on CPU, GPU or by the 4 thermal sensors.

Software controlled, but uses little resources. Uses Corsair RGB only.

After using this for 3 months in an older system to control fan speed / noise I decided to get a second controller. I wanted to have the bottom case fan to be controlled by the GPU temperature. This seems to be my best option I can find to control fans when the motherboard doesn't have enough fan headers.

No strengths. Mine dies within weeks and will burn up if I keep it plugged in.

You will notice that no IPR offered as this is a bad product.

Fortunately, my Creative Labs Sound BladterX AE-5 PCI-E Gaming Sound Card has the same connector as all my corsair RGB and now I control the lighting through this. Corsair quality is going downhill. -2 rating.

None defective unit killed a cpu and motherboard.

Corsairs customer service is not the same beast it once was. horrible experience with them. Basically I am out approximately 400$ from buying this piece of junk

The last 4 products i bought from corsair were all defective 3 came by mail directly from corsair .Their once great quality control is slipping and dealing with corsair rma department was as useless as it was horrible. Wont buy corsair products anymore.

dose as it says and works like a dream

can be a pain to install

using this to control all my fans atm and love it